Two Piece Driveshaft Measuring Guide: Boot - Flange

Information

Two Piece Driveshaft Measuring Guide
Rubber Boot Extension to Flange

IMPORTANT:
Vehicle must be on a level surface with suspension at normal ride height for proper measurements. When measuring to the center bearing, measure to the center of the round or slotted carrier bearing bolt holes. Many carrier mounts are slotted for adjustment.

Two Piece Driveshaft Measuring Guide Boot to Flange

DRIVESHAFT LENGTH:

Measurement (A) - Front Driveshaft Length:
Measure from end of rubber boot extension on the transmission to the center of the carrier bearing bolt holes.

Measurement (B) - Rear Driveshaft Length:
Measure from the center of carrier bearing bolt holes to the flange face on the differential.

SPLINE EXTRUSION LENGTH:

Measurement (C) - Spline Extrusion Length:
Measure from the end of the rubber boot extension to end the of the transmission output/spline. If spline is recessed in rubber boot Extension, enter ø.