Free ground shipping on all driveshafts and orders over $100 within the continental USA! 

Two Piece Driveshaft Measuring Guide: Boot - End Yoke

Information

Two Piece Driveshaft Measuring Guide
Rubber Boot Extension to End Yoke

 IMPORTANT:
Vehicle must be on a level surface with suspension at normal ride height for proper measurements. When measuring to the center bearing, measure to the center of the round or slotted carrier bearing bolt holes.  Many carrier mounts are slotted for adjustment.

Two Piece Driveshaft Measuring Guide Boot to End Yoke

DRIVESHAFT LENGTH:

Measurement (A) - Front Driveshaft Length:
Measure from end of rubber boot extension on the transmission to the center of the carrier bearing bolt holes.

Measurement (B) - Rear Driveshaft Length:
Measure from the center of carrier bearing bolt holes to the end yoke flats (center of ujoint) on the differential.

SPLINE EXTRUSION LENGTH:

Measurement (C) - Spline Extrusion Length:
Measure from the end of the rubber boot extension to end the of the transmission output/spline. If spline is recessed in rubber boot Extension, enter ø.

 

 

Contact Us
Name:*
Email:*
Phone Number:

Measurement A:*

Measurement B:*

Measurement C:*

Slip Yoke Spline Count:*

Transfer Case (4WD) or Transmission (2WD) Model:*

End Yoke U-Joint Series:*

Message:

Page Title: /pages/two-piece-driveshaft-measuring-guide-boot-to-end-yoke

* Required Fields